Technics SL-PD349 Service Manual page 16

SL-PD687 |
No. i P ee een
RefNo. | Removal of the rotary tray
Procedure Procedure 3 etaeeee?
12d
Sand @ Frc
©,
>
ae
1. Pull out the FFC from connector(CN301).
2. Remove 1 connector(CN404).
4. Lift up the main P.C.B. in the direction of arrow, and
release the 2 ribs on the chassis ass'y. Then , remove the
1. Keep the close lock gear pressed in the
direction of arrow, and move the tray
3, Remove the 1 screw(@).
Clamp plate ass'y
1. Remove the 2 screws(@, @).
2. Push the claw in the direction of arrow@, and then remove
the clamp piate ass'y in the direction of arrow@.
Clamp plate ass'y
Claws
'* Release the 3 claws in the direction of arrow.
1. Pull out the FFC trom connector(CN301).
2, Remove 1 connector(CN404),
3. Remove the 4 screws( @ ~
Ref.No. Removal of the mechanism base Ref.No. Removal of the photo transistor
12 ass'y 13 PCB.
Procedure Procedure
1-25-12 S. eo
rc
tO onsor
Pros ansiaor
a !
; consos
3
é Mechanism base ass'y_ vy
* Release the 2 claws in the direction of arrow.
'¢ Release the 3 claws in the direction of arrow, and remove
the sensor P.C.B.
Ref.No. Removal of motor holder and
17 tray motor ass'y
Procedure
12518 ee
1, Remove the 2 screws(@,
2. Remove the motor holder and tray motor ass'y in the
direction of arrow.
2. Pull out the rivet,
3. Remove the belt.
3. Remove the reduction gear.
pe
Sige