Advertisement
-PD687
DISASSEMBLY INSTRUCTIONS
"ATTENTION SERVICER"
ACHTUNG:
je lasereinheit nicht zerlegen.
'Some chassis components may have sharp edges. Be careful when disassembling and servicing.
Waming: This product uses a laser diode. Refer to caution statements on page 2.
Die lasereinheit dart nur gegen eine vom hersteller spezifizierte einheit ausgetauscht werden.
Removal of the tray ass'y
1, Remove the 6 screws(
2. Remove the cabinet in the direction of arrow.
——
Removal of the cabinet
RefNo. | Removal of the front panel ass'y
Procedure
1-2
ceneoa
RetNo. | Removal of the operation P.C.B.
Procedure
1-2-3
Cay
Operation P.C.8.
1, Remove the 10 screws(
@- @).
2, Release the 1 claw.
8, Tiltthe operation P.C.B. in the direction of arrow and
release the bosses. Then, remove the operation P.C.B. in
the direction of arrow@.
2. Remove the 3 screws( @~ @).
3, Pull the front panel ass'y in both direction of arrow to
unlock it from the projections of the chassis assy.
4, Remove the front panel ass in the direction of arrow@)
Claw'of the
Base quietly"
1. Keep the close lock gear pressed in the direction of
arrow@, and move the tray ass'y in the direction of
arrow@,
2. Fit the claw of the tray ass'y in the claw of the tray base
guide(L).
3. Fit the ciaw of the tray ass'y in the claw of the tray base
guide(R).
'Claw of the tray
base 'uide¢r)
4. Pull out the FFC from connector(CN403).
5. Rotate the rotary tray to the position that can be confirmed
the hole@ in the direction of arrow).
Ret.No.
Removal of the tray base guide(L)
6
and tray base guide(R)
Procedure
@
1-2-7568
'
'Tray base guide(R)
Tray base guide(L)
1, Remove the 2 screws(@, @).
2, Remove the tray base guide(L) and tray base guide(R) in
rection of arrow.
5. Push and release the 4 claws in the direction of arow@,
RetNo. | Removal of the power switch P.C.B.
Procedure
124
Power switch P.C.B.
'* Remove the 2 screws( @, @).
1. Remove the 3 screws @- @).
a=
2. Remove the power transformer in the direction of arrow.
and then remove
the tray ass'y in the direction of arrow@.
RetNo. | Removal of the power transformer
RefNo. | Removal of the cable holder
Procedure
Procedure
1-7
12-58
1. Remove the 1 screw( @).
2. Lift the cable holder in the direction of arrow.
ane
Advertisement
