GE 42179 User Manual page 37

3. Connect a coax cable from the TV/POWER on the amplifier
to a grounding block (not included) per the National Electric
Code. Make sure the grounding block is properly grounded.
Refer to your antenna's instruction manual for details. Be
sure to use a rubber boot when connecting the coax cable
to the amplifier. For mast mount, use a large zip tie to
secure the cable to mast. Place the zip tie as close as pos-
sible to the amplifier
4. Connect a coax cable from the grounding block to the input
of the power inserter.
Note: Leave enough slack in the coax cable to create a drip
loop so moisture cannot enter the house. Also seal the coax
cable entry point into your house with exterior caulk.
5. Connect the coax cable pre-attached to the power inserter
to the HDTV.
6. Connect the power supply plug to the power inserter.
7. Plug the power supply into an AC wall outlet. The lighted red
LED confirms power is correctly applied.
8. SCAN FOR CHANNELS ON YOUR HDTV. This step is very
important. Your HDTV will NOT receive signals from your
antenna without completing this step. See your TV's menu
for this process. You can also refer to the TV instruction
manual for detail instructions.
Note: It is important to repeat this process and re-scan for
channels anytime you move or reposition your antenna.
STEP 1
Insert Zip tie into
top holes
Outdoor antenna amplifier
4
STEP 2
Tighten zip tie