GE 42179 User Manual page 36

To protect the amplifier from water, be sure to use the rubber
boots provided.
If you assemble your own cables:
1. Cut the rubber boot as pictured.
2. Pull the cable through the
rubber boot.
3. Attach the coax connector.
If you use pre-built cables
(connectors pre-attached):
1. Cut the rubber boot as pictured.
2. Make 4 slits in the
vertical direction.
3. Pull the cable (with connector)
through the rubber boot. When
connecting to the amplifier, use a
small zip tie to secure the rubber
boot to the cable.
Outdoor amplifier installation
1. Connect a coax cable from your antenna to the ANTENNA
on the amplifier. Be sure to use a rubber boot, and for best
results, keep the cable between the antenna and amplifier
as short as possible.
2. Mount the amplifier in your desired location.
• Mast mount: Use a large zip tie to secure
amplifier to mast.
See picture on the following page.
• Wall mount: Use the slotted holes at the top of
the amplifier to attach to wall.
INSTALLATION
3