Advertisement
6. Regular Installation Guide (Figure 2)
Out Swing Door
Installation
1
Template
Fold the CX-90S Template along the dotted
line upto 90°.
Note: Installation Template Only for In-door
E.M. Lock Model 300, 600, 1200
4
Drill 2 holes on Frame and 3 holes on
door as indicated on the template.
6
Door
Rubber
Washer
This allow the armature plate to pivot
around the armature screw to
compensate for door misalignment.
Cover Screw
Cable Wire
9
** T Handle
Fixing
Screw
PCB
x2
Cover
Anti
Allen
Tamper
Included
Wrench
Nut x2
Use an Allen key wrench to unscrew
the anti tamper nut and tighten the
fixing screws on the mounting plate.
2
Door Frame
Template
Door
Out Swing
Close the door, position the EM lock
mounting location as close to the
door upper corner with gap 10mm.
5
Armature
Screw
Armature
Plate
Rubber
Washer
Install the Armature Plate to the door.
Note: Actual installation may varies according to door figures.
7
Mount the FB600 on the door frame
by screw in the self tapping screw on
the holes as indicated on template.
10
Door Frame
Allen Key
3mm
Not
Door
Holding Force
Connect to power supply and test the
unit.
3
Place the template against the door &
frame and drill holes according to
template indications.
Wooden Door
Sexnut Bolt
Metal Washer
8
Once position is correct, screw in
others screws to permanently mount
the plate; and drill the wire cable
access hole.
EM
Lock
Page 3 of 4
CX-90S-03 Door Magnetic Locks
Door
Door
Advertisement
