Heathkit SG-8 Manual page 15

-_
—_
(
(
(
(
(
(
)
)
)
)
— — _—
—
—
—
—
—
)
)
)
)
)
)
)
)
)
)
)
Connect the other wire to TB2 (NS).
Connect a 47 82 resistor from N11 (NS) to N5 (NS).
Connect a 47 22 resistor from N11 (S) to N3 (NS).
Connect a 680 22 resistor from N3 (S) to Nd (NS).
Connect a 680 {2 resistor from N65 (S) to N7 (NS).
Nw
Awe an 4L~ Lf. -
Connect the free end of the wire coming from TA3 (see Pictorial 2) to
shown in Pictoria
i3(S). Run wire as
—
bed
N2 (8). Cover wire with a 2 1/2" length of spaghetti. Run wire
th wt t main th DMR ATIT anes artings Ann
Connect a bare wire t
et Pan e RF OUT connection (S). nce
om
through grommet &£
Pictorial 4.
Connect a short bare wire from the lug on the RF OUT connector (S) to the pilot light ter-
minal nearest the panel (S).
Connect the free end of the yellow transformer wire to the rear pilot light terminal (NS).
Connect a short bare wire from Gl (S) to K12 (S).
) Connect a 5600 2 resistor from G5 (S) to TD1 (S).
Connect a 330 2 resistor from G7 (S) to the solder lug (NS).
Connect a 390 K® resistor from K8 (NS) to K10 (S).
Page 13