Heathkit SG-8 Manual page 12

)
—
—
—
—
Mountthe audio choke on top of the chassis to the-rear of the tube socket. Use 3/8 6-32
screws, placing a solder lug under the nut nearest the tube socket and the lockwasher under
the other nut. Position the solder lug as shown in Figure 6.
Mount the power transformer on top of the chassis opposite the audio choke. Position the
transformer in such a manner that the red and yellow leads pass through the grommet near-
est the chassis edge.
On the back mounting screw of the transformer, place a solder lug on the under side of the
chassis. Position as shown in Figure 6.
On the front mounting screw, mount a 2-lugterminal stripTC. Position as shown in Figure
6. Use a lockwasher under the nut.
solder lug at hole H and a 3-lug terminal strip TB at hole
urea &
re 0.
nd co ime. Lower the sub-chassis thr
angle to clear the E ba snd coils, and at the same time permit the ba
down into the slotted hole in the front of the chassis.
\k g\\ Op he
if] [sae '
Lakes (SS