Heathkit SG-8 Manual page 14

~~
~——
_
—
( )
( )
( )
( )
Page 12
Connect either y w wi m tl an m
Run the other yellow lead as shown in Pictorial 3
The 20-20 ufd 150 volt filter condenser has two leads on the end marked "positive, "' and
one lead on the other end. The condenser is mounted between the solder lug and the ter-
minal strip TC as shown in Pictorial 3.
Connect the single negative wire to the solder lug (S).
Connect the two positive wires of the condenser to TC1 and TC2 (NS).
Connect a wire from the positive rectifier terminal (S) to TC2 (NS).
Connect a 3.3 KQ 1 watt resistor from TC2 (S) to TC1 (NS).
) Twist two wires about 10" long together. Connect one pair of wire ends to the two switch
terminals on the back of control M (S).
Run the wires as shown in Pictorial 3 to the terminal strip TB. Connect one wire to TB1
(S).
PICTORIAL 4 »