Cleaning And Lubricating The Drive Chain - Yamaha FZ6 2006 Owner's Manual

NOTE:
Using the alignment marks on each
side of the swingarm, make sure that
both chain pullers are in the same posi-
tion for proper wheel alignment.
1. Locknut
2. Drive chain slack adjusting nut
3. Axle nut
4. Alignment marks
CAUTION:
Improper drive chain slack will over-
load the engine as well as other vital
parts of the motorcycle and can lead
to chain slippage or breakage. To
prevent this from occurring, keep
the drive chain slack within the
specified limits.
PERIODIC MAINTENANCE AND MINOR REPAIR
3. Tighten the locknuts, then the axle
nut to their specified torques.
Tightening torques:
Locknut:
16 Nm (1.6 m·kgf, 11 ft·lbf)
Axle nut:
120 Nm (12.0 m·kgf, 85 ft·lbf)
ECA10570
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
CAUTION:
The drive chain must be lubricated
after washing the motorcycle and
riding in the rain.
1. Clean the drive chain with kero-
CAUTION:
To prevent damaging the O-rings, do
not clean the drive chain with steam
cleaners, high-pressure washers or
inappropriate solvents.
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
6-23
sene and a small soft brush.
chain with a special O-ring chain
lubricant.
EAU23022
ECA10581
6
ECA11120