Advertisement
cS Operating Tips
Clean the
Lint Filter...
*
after each load.
($
-
¢ to shorten drying time.
* to operate more energy efficient.
NOTE: Do not operate the dryer without the lint
filter in place.
Load the Dryer Properly...
*by
placing
only one
washload
in the dryer at
a time.
* by avoiding very small loads or mixed loads.
«by adding one or more similar items to the dryer
when only one or two articles need drying. This
improves the tumbling action and drying efficiency.
Add A Fabric Softener Sheet...
(If So Desired)
* after loading the dryer.
* to control static cling.
* before the load becomes warm. This helps prevent
greasy—looking softener stains.
¢ and remove any used softener sheets from the dryer
to prevent greasy—looking softener stains.
Use A Drying Rack...
(Found in select models or purchased sep-
arately from your dealer using part
#LAX1000XXX.}
* to dry items, such as sneakers,
pillows, caps,
stuffed toys, washable
sweaters, etc. inside the
dryer without tumbling. (Make sure nothing hangs
over the edge of the rack.)
* with a Time Dry heat cycle or an Air Fluff cycle
according to care label recommendations.
¢ by positioning the rack in the tumbler with the
front facing you. The legs should rest firmly on the
front and back of the drum.
Check the Moisture Monitor...
Indicator lights in the moisture monitor will display
when an IntelliDry cycle is in operation. The top light
will blink on and off. As loads dry, there will be longer
pauses between each blink. No lights will display during
Time Dry.
The bottom light in the monitor will remain on until the
cool down portion of the cycle starts. During cool down
the dryer continues to tumble the load in unheated air to
help minimize wrinkling.
NOTE: The top monitor light may not blink when
small loads of heavy, bulky items are dried, such as
large rugs or sweaters.
Advertisement
