Toro Flex-Force Power System 88924 Operator's Manual page 11

4. If multiple battery packs are connected to the charger, you can switch
between batteries or charge both at the same time by pressing the
charging mode button on the side of the charger.
Note:
The LED indicator lights to the left and right of the button tells
you which side (or sides) are currently charging.
5. To remove the battery pack, slide the battery backward out of the
charger.
6. Refer to the following table to interpret the LED indicator lights on
the battery charger.
Indicator Status
light
Off
State of Green
charge lights blinking
Green
Blue
Temperature
light
Red
Fault light Red,
blinking
*Refer to Troubleshooting (page 13)
Important:
The battery can be left on the charger for short periods
between uses.
If the battery will not be used for longer periods, remove the battery
from the charger; refer to
Indicates
No battery pack inserted
Battery pack is charging
Battery pack is fully charged
Battery pack and/or battery charger is under the appropriate
temperature range
Battery pack and/or battery charger is over the appropriate
temperature range
Battery pack charging fault*
for more information.
Storage (page
11
12).