Mechanical Drawings - Philips CDF 100 Service Manual

IMPORTANT
This product was FCC certified under test conditions that included use of shielded cables and connectors between
system components. It is important that you use shielded cables to reduce the possibility of causing interference to
radios, television sets and other electronic devices. If you have any problems contact your dealer.
LASER SAFETY
This unit employs a laser. Do not remove the cover or attempt to service this device when connected to the mains, due to
the possibility of eye damage.
CAUTION
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS LASER RADIATION EXPOSURE.
important notice:
Make sure before connecting this drive unit to the mains/AC power via the wall adapter,that the voltage used matches
the voltage setting of the wall adapter. Refer to the type sticker at the adapter.
CAUTION:
During transport you must ALWAYS use the transport path !!!
Model: n Vi
CDF 100/00 Europe PAL
CDF100/05 United Kingdom PAL
CDF100/11 Japan NTSC
CDF100/17 USA NTSC
PCS 67 428
2.1
292
2.4
3.1
3.2
3.2.1
3.2.2
3.2.2.1
3.2.3
3.2.3.1
3.3
3.3.1
3.3.2
333
3.3.4
3.3.5
3.3.6
3.3.7
3.3.8
3.3.9
oO gaAAGaAGGGgGA
oa aoa ek de
ONaMoOaRWN =
7.2
7.3
7.3.1
7.3.2
7.3.3
7.3.4
7.3.5
7.3.6
7.3.7
7.3.8
7.3.9
DETAILED TABLE OF CONTENTS
PRODUCT INFORMATION
Technical specification
Input voltages
Remote control system
Power supply and rechargeable battery pack.
SERVICE INFORMATION
Safety instructions
Servicing of SMDs (Surface Mounted Devices)
General cautions on handling and storage
Removal of SMDs
Caution on removal
Attachment of SMDs
Caution on attachment
Handling ESD sensitive components
Personal safety
Storage and transport
Testing or handling
Mounting ESD sensitive components
Soldering
Electrostatic charges
Transients (switch-on phenomena)
Working environment
Replacement of the Flat Pack |.C.s
Service tools like testdiscs
Measuring equipment
MECHANICAL DRAWINGS
Demounting instructions
Exploded view
Demounting of flex foil CDM-9
Packaging instructions
SHORT DESCRIPTIONS
Data of components
Compact disc mechanism: CDM-9
Photo diode signal processor TDA 8808
Radial error signal processor TDA 8809
Decoder SAA 7310
Single-bit DAC (bit stream) SAA 7321
Bitstream technology information
Compact Disc Blockdecoder CDBD
Eve Video Controller EVC
Explanation of analog video part
THE SERVICE DIAGNOSTIC SOFTWARE
ELECTRICAL DRAWINGS
Wiring diagram
Block diagram
Circuit diagrams and PCB layouts
Power supply and PCB layouts (two sides)
Servo & decoder panel and PCB layout
Audio/video panel PCB layouts
Audio output part
Digital video part |
Digital video part Il
Audio/video pane! PCB layouts
Analog video part
Display + I.R. circuit diagrams and PCB layouts
DIAGNOSTICS
Measurements and adjustments
Trouble shooting/quick diagnostics
PERSONAL NOTES
PARTSLIST OF MECHANICAL- AND ELECTRICAL PARTS
PCS 67 429