Pioneer XR-P460 Service Manual page 27

_ XR-P360, XR-P360G |
1.5 CD SLOT-IN MECHA
@ How to install the disc table
1] Use nipper or other tool to cut the three sections marked
@® figure [1]. Then remove the spacer.
(2] While supporting the spindle motor shaft with the stopper,
put spacer on top of the motor base (angled so it doesn't
touch section ®), and stick the disc table on top (takes
about 9kg pressure). Take off the spacer.
of about 9kg) 3.1mm
(Pressure
2
£0.05mm
Disc
table | |
|
St 6.9mm
PCB Carriage
Spacer setting
Position
Spindle motor base