Philips VR202 Operating Instructions Manual page 19

If the display shows another indication, e.g. 'DAILY' or 'WKLY',
press button SEL one or more times until the display shows
'DATE'.
@ Press button 9RC.
The display will show, e.g.:
Programming a recording which takes place daily or weekly:
You may programme a recording which will take place daily or
weekly at step O, entering the date of the recording.
If you wish to repeat the recording at the same time every day:
i7?.T7g:l
1
START
END
on.on date c
LU'UU u
O I
-I
It
l-PROG-i
I I
L rUU"'""*"U 1
Now enter the programme number of the TV channel from which
you wish to record.
© Press button ®RC once more to complete the timer
programming.
The display will show, e.g.:
VCR1
START
on. on
L.
U'UU
DATE
END
o
I.nn
PROG
I'UU
11111111111
'TRANSMIT
11111111111
o
Please note:
You may now proceed with the programming of other
TIMER-blocks and then with transmitting them one by one, to the
video recorder.
O Transmit the data to the video recorder. To do this, aim the
remote control at the video recorder and press the button
O))). The recording details are now being transmitted to the
video recorder.
The video recorder display shows the symbol
ESB.
• If the transmission Is accepted the video recorder display will
show, e.g.:
The programming sequence Is concluded.
• If an error occurred while either programming on the remote
control or during the transmission, the Indication 'ERROR' will
appear on the video recorder display.
Should this be the case then go back and check all the data you
have entered and transmit it again.
• Programme the TIMER-block as usual introducing the
starting time and the ending time (steps O to @).
• When entering the date of the recording press button SEL
until the indication 'DAILY' appears on the display:
• Now press the digit buttons 0-9 to enter the date, on which
the first recording is to be made.
• Conclude the programming sequence as usual following
steps @ to O.
If you wish to repeat the recording on the same day and at the
se time every week:
• Programme the TIMER-block as usual introducing the
starting time and the ending time (steps ©to @).
• When entering the date of the recording press button 0-9
until the Indication 'WKLY' appears on the display:
tW/JdrI
1
START
END
_ _ _ _ I I I 1 I.-
on.Of t:DATE-rto
L. L«i' L.i U W.I
O
i.nn
L
ruu
WKLY
• Press now the digit buttons 0-9 to enter the date, on which
the first recording is to be made.
• Conclude the programming sequence as usual following
steps © to O.
Please note:
• If during the programming sequence a button is not pressed
for 1 minute, you have to start the programming of this
TIMER-block from the beginning again.
• The content of the TIMER-blocks remains stored in the
remote control. You may therefore recall any of the
TIMER-blocks to check It or correct it as and when you please.
How do I recall and transmit stored TIMER-blocks?
O Press button 9RC.
The TIMER-block you used last, will appear on the remote
control display. All its programming details will be displayed.
© Using buttons + or — you may recall the other
TIMER-blocks.
@ By pressing button O))) you may now transmit all stored
TIMER-blocks one by one to the video recorder.