Table of Contents
Advertisement
Table continued from last page
Problem:
Door is difficult to open:
Appliance sides are warm:
LED lighting does not work:
Signal light above the 2, 3 or
5 indicator flashes:
Signal light above the D or E
indicator flashes:
Signal light above the 8
indicator flashes:
If the above tips do not resolve your problem, call the nearest authorized service centre and state the
type, model, and serial number indicated on the appliance rating plate or label located in the appliance
interior.
34
Cause or remedy:
•
Door not closed correctly (possible impurities on the seal,
misaligned door, damaged seal etc.).
•
An extended power failure.
•
Too much fresh food inserted at once.
•
If you are trying to open the freezer door after just having closed
it, this could be difficult to do. As you open the door, some cool
air escapes from the appliance and it is replaced by warm air
from the environment. When this air is cooled, negative pressure
is generated which results in problems as you try to open the
door. After a few minutes, the condition is normalized and the
door can be easily opened again.
•
This is normal. There are pipes and tubes installed in the
appliance sides, which tend to heat up during appliance
operation.
•
If LED lighting does not work, call a service technician.
•
Do not attempt a repair of the LED lighting yourself, as there is
danger of contact with high voltage!
•
Temperature sensor error or fault. Call a service centre for repair.
Until the appliance is repaired by a service technician, the
appliance will operate in safe mode. The appliance will
automatically preserve the most suitable temperature for each
compartment.
•
Sensor keys are not responding. Call a service centre for repair.
•
Until the appliance is repaired by a service technician, the
appliance will operate in safe mode. The appliance will
automatically preserve the most suitable temperature for each
compartment.
•
Door was open for too long. Close the door.
•
If the lighting in the compartment does not function either, then
there is a door sensor fault. Call a service centre to arrange a
repair. The appliance will operate in safe mode until it is repaired.
The appliance will automatically preserve the most suitable
temperature for each compartment.
Advertisement
Table of Contents
