Appliance Interior Equipment; Shelf; Wire Bottle Rack; Fruit And Vegetable Bin With Humidity Control (Crispzone) - Smeg Universale Aesthetic RC18WNE Instructions For Use Manual

Appliance interior equipment

( * Equipment depends on the model)

Shelf

Wire bottle rack *

Fruit and vegetable bin with humidity control (CrispZone) *

• The drawer at the bottom of the refrigerator is intended for storing fruit and vegetables. It provides
humidity and prevents the food from drying out. The drawer has a humidity regulator which allows
setting the humidity level.
24
You can lay out the empty shelves to your liking across the guides in the
refrigerator interior without having to remove them from the refrigerator.
To move the shelf or take it out from the refrigerator, slightly lift it at the
back, pull it towards you, and then either move it or take it out of the
appliance. Store quickly perishable food at the back of the shelf where
the temperature is the lowest.
• Some models also feature a wire bottle holder. It is protected against
being inadvertently pulled out. It can only be pulled out when it is
empty. To pull it out, lift it slightly at the front and pull it towards you.
Place the bottle holder so that the length of the bottles does not
prevent proper closing of the door.
The holder can take a maximum load of nine 0.75-litre bottles or 13
kilograms of total weight see label on the right side in the appliance
interior.
• Cans may also be placed on the bottle rack (lengthwise or crosswise).
Slider position to the right: closed vents, higher humidity in the bin.
Slider position to the left: open vents, lower humidity in the bin.
If you observe droplets accumulating below the glass shelf, open the
vents and wipe the shelf (see chapter TROUBLESHOOTING).