Table of Contents
Advertisement
4
Installation
Read the "Safety Instructions" section
first!
4.1. Appropriate Installation
Location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and ensure
that electrical installation and water
installation are appropriate. If not, call a
qualified electrician and technician to have
any necessary arrangements carried out.
WARNING: anufacturer shall not
be held liable for damages that
may arise from procedures carried
out by unauthorized persons.
WARNING: Product must not be
plugged in during installation.
Otherwise, there is the risk of
death or serious injury!
WARNING: If the door clearance
of the room where the product shall
be place is so tight to prevent
passing of the product, remove the
door of the room and pass the
product through the door by turning
it to its side; if this does not work,
contact the authorized service.
Place the product on an even floor
•
surface to prevent jolts.
Install the product at least 30 cm away
•
from heat sources such as hobs, heater
cores and stoves and at least 5 cm
away from electrical ovens.
Product must not be subjected to direct
•
sun light and kept in humid places.
Appropriate air ventilation must be
•
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least 5
cm distance with the ceiling and side
walls.
Please provide at least 5cm distance for
•
air circulation between the back side of
your product and the wall to avoid
condensation on the rear panel of
product.
Your product requires adequate air
•
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
If the product will be placed in an
•
alcove, remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
Check if the rear wall clearance
protection component is present at its
location (if provided with the product). If
the component is not available, or if it is
lost or fallen, position the product so
that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
4.2. Adjusting the Feet
If the product stands unbalanced after
installation, adjust the feet on the front by
rotating them to the right or left.
Advertisement
Table of Contents
