Table of Contents
Advertisement
Use this to set the volume at which the effect begins to take
effect. The more the value is increased, the higher the volume
needed before the effect kicks in. If there is a lot of noise
present, raise the value; if there is relatively little noise, you can
lower the value. Adjust it so that when the guitar is not being
Played, the noise is removed, while the decay of the guitar still
sounds natural.
* Setting the Threshold value too high may suppress the sound so much that
no sound will be heard when the guitar's volume is at a low setting.
DELAY
Delay adds an echo effect to the sound.
FEEDBACK (0 ~ 10D)
Select fram two types of delay.
7
This adjusts the delay
This adjusts the amount of
{NORMAL) Normal
===
time.
feedback {number of
An ordinary delay.
repeats) of the delay.
Feedback increases as the
The delayed
sound is
panned across the left and
right channels.
* When the ME-30 is used in mono
(ona single channel), then the delay
will be mono, even if PAN is selected.
Vi
Advertisement
Table of Contents
