Panasonic Omnivision PV-9401 Operating Instructions Manual page 6

Jne time VCH
etup
When VCR is turned on the first time,
setup mode is entered automatically.
Turn the TV and VCR on.
Press POWER.
Tune to VCR output channel.
Tune TV to CH3 or CH4.
(Same as back of VCR)
* Always tune TV to this channel to
monitor the VCR.
* If you used audio/video jack connection,
tune the TV to its video input.
CH3 or CH4
PUSH VCR CH 4: ENGLISH for English
OPRIMIR VCR CH ¥: ESPAÑOL for Spanish
APP. VCR/TV
: FRANCAIS
(ESPANOL)
for French
(FRANCAIS)
(TV Screen)
» Use remote or VCR buttons.
* If wrong language is set, do
"Reset All VCR Memory Functions"
steps page 34.
Select hookup.
1) Press AV to
select.
2) Press P to set.
* If you selected "CABLE/ DSS BOX
> VCR > TV," continue with step 5
and only the cable box output
channel will be placed in memory.
If mot, go to step 7.
SELECT HOOKUP
CABLE/DSS BOXPVCRETV
VCRPCABLE/DSS BOXPTV
VCR>TV
SELECT:á Y KEY
SET :» KEY
END :ACTION KEY
Select cable box
or DSS receiver
output channel.
1) Press AV to
select.
2) Press P to enter.
* If necessary, refer to cable box
manual.
* If you used Audio! Video jack
connection to cable box, set
"VIDEO OUT".
SELECT HOOKUP
CABLE/DSS BOXPVCRP TV
CABLE/DSS BOX OUTPUT CH
SELECT:A ¥ KEY
z4 > KEY
¡ACTION KEY
* If you use DSS receiver, it must be turned off.
Process of Setup
1 POWER
3 verv
SELECT/
3 CHa
Model PV-9451 remote is shown here.
IMPORTANT NOTE FOR
AUTO CLOCK SET
Auto clock set is performed the first
time the VCR is turned off each
day. If used, a cable box must be
left on and tuned to the PBS
channel at the time VCR power is
turned off if you want auto clock set
to be done.
ii used, a DSS receiver must be
turned off for auto clock set.
lf Cable Box or DSS receiver is
connected to VCR via Audio/Video
jacks, an RF coaxial cable must
also be connected for auto clock
set and channel auto set features.