Panasonic Omnivision PV-9401 Operating Instructions Manual page 18

WuIti-Brana Control Feature
The Remote Contro! may be set up to control some TV or Cable/DSS Box functions.
Multi-Brand Control Setup
Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
POWER
Setup for TV
Setup remote.
D Wor
Hold down TV and enter code DSS/ CABLE
with NUMBERED keys.
Hold down DSS/CABLE and
enter code with NUMBERED keys.
* For code 100 or greater, press the
100 key first, then remaining digit.
E.g. for 102, press 100, then press 0, D NUMBERED
and then press 2.
keys
Confirm code entry.
Press POWER to turn
selected unit ON or OFF.
* See table below for list of
controllable functions in each mode.
Cp e Please repeat Multi-Brand Control setup after replacing
remote control batteries.
* The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers listed. If you get no
results, your particular brand cannot be controlled.
After remote contro! is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
Buttons VCR TV
All Functions VOL UP/DOWN
TV
JECT, SAP/ Hi-Fi (PV-
NUMBERED keys,
eet only), DISPLAY, TER CH UPIDOWR
FF, REW, PAUSE, SLOW,
REC, SPEED, ZERO/ VOL UP/DOWN
1MIN, COUNTER RESET
CABLE/ DSS
CABLE/ DSS VCR/TV, PLAY, STOP
EJECT, SAP/ Hi-Fi (PV-
9451 edt DISPLAY FF,
REW, PAUSE, SLOW,
REC, SPEED, ZERO/
1MIN, COUNTER RESET
VOL UP/ DOWN POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/ DOWN
18 For assistance, call 1-800-211-PANA(7262).