Advertisement
6.
TROUBLESHOOTING
PROBLEM
Irregular darkening or dimming.
The filter won't darken or flickers.
Filter darkening without arc being struck.
Filter remains dark after completing a
weld.
Slow response.
Welding helmet slips.
This document has been drawn up according to Regulation (EU) 2016/425 as amended to apply to GB for Personal Protective
Equipment. The declaration of conformity can be accessed at www.sealey.co.uk.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack
Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
EU | Sealey EU Ltd, Farney Street, Carrickmacross, Co. Monaghan, A81 PK68 Ireland
UK | Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
POSSIBLE CAUSE
Headgear has been set unevenly so there
is an uneven distance from the eyes to the
filter lens.
Front cover lens is dirty or damaged.
Sensors are dirty/blocked.
Solar panel is blocked.
Sensitivity is set too low or the delay time
is too small.
Welding current too low.
Sensitivity is set too high.
Delay time is set too long.
Operating temperature is too low.
Headgear is not properly adjusted.
sales@sealey.co.uk
Original Language Version
SOLUTION
Readjust the headband.
Clean or replace the lens.
Clean the sensors surface.
Ensure the solar panel is free from
obstruction whilst welding.
Adjust sensitivity/delay time to required
level.
Adjust weld amps.
Adjust sensitivity to required level.
Adjust delay time to required level.
Do not use at temperatures below -10
or 14
F.
o
Readjust the headband.
www.sealey.co.uk
PWH602
Issue 2
C
o
REGISTER YOUR
PURCHASE HERE
15/02/24
Advertisement
