Advertisement
4.
OPERATION
NOTE: Consider environmental conditions where helmet is being used and be aware of use in these conditions, stop using if feeling
fatigued or unwell.
WARNING! Before using the helmet for welding make sure you have read and understood the safety instructions in Section 1.
‰
Make sure there is no dust on any sensor.
9
Set the exact mode that you need.
9
If the battery icon is flashing, please change the battery before use. See 4.7.
4.1.
FITTING INSTRUCTIONS
4.1.1. The circumference of the headband is adjusted by turning the wheel on the rear (fig.1).
4.1.2. The two top straps can also be adjusted by releasing the pin from the top strap and adjusting as required (fig.2).
4.1.3. The distance between the headband assembly and the helmet can be adjusted by undoing the external thumbwheels both sides, and
sliding the headband assembly forwards or backwards, as required. Retighten the thumbwheels.
4.1.4. Test the fit of the helmet by lifting it up and closing it a few times whilst wearing it. If the headband moves whilst tilting, readjust it until it
is stable.
FIG.1
4.2.
MODES
4.2.1. The ADF has 4 modes: CUT (4-8), WELD (9-14), GRIND and DARK.
4.2.2. The mode can be selected using the internal or external controls, as shown below.
WARNING! DO NOT weld in GRIND mode.
‰
4.3.
INTERNAL CONTROLS
4.4.
EXTERNAL CONTROL BUTTON
4.5.
MEMORY MODE
© Jack Sealey Limited
FIG.2
ADJUSTMENT
WHEEL
Press MODE
Hold MODE for 1s
Press SILICON button
Hold SILICON button
Twist the knob
Original Language Version
ADJUSTMENT
STRAPS
Select the mode from WELD, CUT, DARK
Automatic shade function ON/OFF
Saves the welding mode in record 0.
Switches to grind mode
Manual mode, shade will be adjusted by +0.5
Auto Shade mode, shade deviation +0.1
PWH602
Issue 2
15/02/24
Advertisement
