Environment And Safety - Philips DCTG6921S Manual

Hide thumbs

Table Of Contents

Table of Contents

Safety information: This telephone is not designed for making emergency telephone calls when the power fails. An

alternative should be made available for access to emergency calls.

Power requirements: The product requires an electrical supply of 220 volts, single phase alternating current,

excluding IT installations defined in standard IEC 60950.

Battery requirements: The handset requires power source of two rechargeable NiMH batteries, size AAA 1.2V

650mAh (HR10/44).

WARNING! The electrical network is classified as dangerous according to criteria in the standard IEC 60950. The

only way to power down this product is by unplugging the power supply from the electrical outlet. Ensure the electrical

outlet is located close to the apparatus and is always easily accessible.

Telephone connection: The voltage on the network is classified as TNV-3 (Telecommunication Network Voltages, as

defined in the standard IEC 60950). Following a power cut, the call in progress is lost.

Safety precautions:

•

Do not allow the handset to come into contact with liquids or moisture.

•

Do not open the handset, base station or charger. This could expose you to high voltages.

•

Do not allow the charging contacts or the battery to come into contact with conductive materials.

•

There is a slight chance that the telephone could be damaged by an electrical storm. It is recommended that

users unplug the phone from the mains supply and telephone socket during a storm.

•

Do not use the handset in an explosive hazard area such as where there is gas leaking.

Environmental care: Please remember to observe the local regulations regarding the disposal of your packaging

materials, exhausted batteries and old phone and where possible promote their recycling.

Because the phone works by sending radio signals between the base unit and the handset, wearers of hearing aids may

experience interference in the form of a humming noise.

We advise that this phone should not be used near intensive care medical equipment or by persons with pacemakers.

Your phone can interfere with electrical equipment such as answering machines, TV and radio sets, clock radios and computers if

placed too close. It is recommended that you position the base unit at least one meter from such appliances.

CAUTION

Use only the mains adapter supplied with this telephone. Incorrect adapter polarity or voltage

can seriously damage the unit.

Base adapter

Input: 220 VAC 50 Hz

Output: 9 VDC 500 mA (DCTG 695xx)

Output: 9 VDC 300 mA (DCTG 692xx)

CAUTION

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. Never use non-

rechargeable batteries; use recommended type supplied with this telephone. NiMH batteries

must be disposed of in accordance with the applicable waste disposal regulations.

Hereby, Philips declares that the DECT 692xx and the DECT 695xx are in compliance with the essential requirements

and other relevant provisions of Directive 1999/5/EC. This product can only be connected to the analogue telephone

network of the country indicated on the sticker located under the base station.