Vetus E-DRIVE MPE1MBV User Manual page 7

3.5 Meaning of LED warning symbols
Startup sequence
Propulsion active (propeller moving) - Normal mode
Power mode active. Propeller not moving
Propulsion active (propeller moving) - Power mode
CAN warning - Blockage (overload)
CAN alarm - High voltage (alternating red/green)
Overheating warning (motor is limited but functional)
Overheat alarm
High motor current (voltage battery indication impossible)
3.4 Meaning of LED battery charge indicator symbols
24 V system @ 0 - 10 A
> 25.4 V
24.6 - 25.4 V
23.6 - 24.6 V
22.4 - 23.6 V
21.6 - 22.4 V
24 V system @ >10 A
> 25.4 V
24.2 - 25.4 V
23.0 - 24.2 V
22.2 - 23.0 V
21.6 - 22.2 V
The level shown on the battery charge indicator is based on the volt-
age measured.
- If more power is being used, the cruising range will decrease, and
the level shown on the battery charge indicator will be lower.
- If less power is being used (you're sailing slower), it will be pos-
sible for the voltage to increase again. The same applies for the
level shown on the led battery charge indicator.
Owner's manual MPE1MBV E-DRIVE Monitoring Panel
When switched on, all LED symbols light up momentarily
x
x
x
x x
x
24 V system @ 0 - 10 A
> 50.8 V
49.2 - 50.8 V
47.2 - 49.2 V
44.8 - 47.2 V
43.2 - 44.8 V
24 V system @ >10 A
> 50.8 V
48.4 - 50.8 V
46.0 - 48.4 V
44.4 - 46.0 V
43.2 - 44.4 V
The level shown on the battery charge indicator on the
MPE1MBV panel is an approximate level only. Use a battery
monitoring system (CANNS500) to get a more accurate read-
ing.
ENGLISH
x
(x)
(x) x
(x)
(x) = flashes, x = continuously on
LED battery charge indicator
LED battery charge indicator
n
ote
370602.01
(x)
x
7