Vetus E-DRIVE MPE1MBV User Manual page 6

ENGLISH
1 Safety
Warning indications
Where applicable, the following warning indications are used in this
manual in connection with safety:
Indicates that great potential danger exists that can lead to serious
injury or death.
Indicates that a potential danger that can lead to injury exists.
Indicates that the usage procedures, actions etc. concerned can re-
sult in serious damage to or destruction of the engine. Some CAU-
TION indications also advise that a potential danger exists that can
lead to serious injury or death.
Emphasises important procedures, circumstances etc.
Symbols
Indicates that the relevant procedure must be carried out.
Indicates that a particular action is forbidden.
Pass on the safety instructions to others using the E-LINE motor.
General rules and laws concerning safety and accident prevention
must always be observed.
This product should only be operated by persons who have
read and understood the instructions and precautions in this
manual. Failure to follow the instructions in this manual may
result in serious injury or property damage. The manufacturer
shall not be liable for any damages resulting from improper
operation.
6
370602.01
D
anGer
W
arninG
c
aution
n
ote
W
arninG
2 Introduction
This manual gives guidelines for the use of the VETUS MPE1MBV
E-DRIVE key switch
Unauthorised modifications shall exclude the liability of the manu-
facturer for any resulting damage.
• During use ensure the correct battery voltage is available.
Changing over the plus (+) and minus (-) connections will
cause irreparable damage to the installation.
Never work on the electrical system while it is energized.
3 Operation
3.1 Switch on
Make sure that the on-board power supply and the power supply of
the V-CAN line are switched on.
When the power is switched on, all LED symbols light up momentarily.
3.2 Switch off
• Switch off the power. When the power is off, all LEDs are off.
• Turn off the on-board power.
3.3 Alarm
Switching off the audio signal
• Press the mute button to
switch off the audio signal.
If a problem has not been
solved, the LEDs will not
switch off.
Resetting the alarm
Fix the problem before resetting the alarm.
• Press and hold the mute button until you hear a beep. The alarm
has now been reset.
Owner's manual MPE1MBV E-DRIVE Monitoring Panel
W
arninG
W
arninG
c
aution