Table of Contents
Advertisement
Spreader Pattern Adjustment
If the spread pattern is skewed or dispensing too
light/heavy to one side (see
adjust the gate as follows:
Figure 25
1. Heavy to left side
2. Move ramp pattern to
shaded position
Note:
Do not adjust the ramps to split product flow.
Use only the front or rear ramp positions as shown.
To adjust when the material pattern rotate the spread
pattern control knob:
•
Clockwise if heavy on left side.
•
Counterclockwise if heavy on right side.
Figure 26
1. Spread pattern control knob
Figure 25
and
Figure
26),
g025543
3. Heavy to right side
g387255
30
Advertisement
Table of Contents
