Grandstream Networks RPS-60W-B Quick Installation Manual page 4

Step 3: Place the RPS horizontally into the bracket. Please ensure that the
power cord is located on the side of the RPS silicone plug.
Step 4: Lower the bracket cover and ensure that the screw holes are aligned.
Then, use the fixed screw (M3*6) to lock the RPS inside the bracket.
Step 5: Lift the RPS silicone plug from the arrow side and rotate it 90° clock-
wise to see the power hole, next connect the RPS to the switch, then connect
the AC power cord to the RPS, finally complete the connection between the
power cord and the power supply system.
90°
~3~
Step 6: To prevent accidental disconnection of the RPS, it's recommended
to use a power cord anti-trip for installation. Place the smooth side of the fixed
strap towards the power cord and connect it to the anti-trap hole below the
power cord.
Step 7: Slide the protective rope over the fixed strap until the end of
the power cord, then smoothly wrap the strap around the power
cord and lock it tightly.
Refer to online documents and FAQ for more detailed information:
http://www.grandstream.com/our-products
3
~4~