Scag Power Equipment V-Ride XL Series Operator's Manual page 35

Section 6
WARNING
Always wear proper hand and eye protection
when working with cutter blades.
3. Check the measurement from the floor to the cutter
blade tip at the front and rear of the left side blade.
If the measurement is not at 3", an adjustment must
be made using the cutter deck adjustment lever.
Adjust as follows:
A. Loosen the elastic stop nuts securing the deck
level links on the front and rear of the cutter deck. See
Figure 6-6.
B. Turn the adjustment bolts on the front and rear either
clockwise to raise or counterclockwise to lower the front
of the cutter deck until the measurements are equal.
Tighten the elastic stop nuts.
LOOSEN HERE
ADJUST HERE
Figure 6-6. Left Side Cutter Deck Adjustment
4. Rotate the cutter blade on the right side of the cutter
deck. Position the cutter blade so it is facing "front to
back" on the machine.
5. Check the measurement from the floor to the cutter
blade tip at the front and rear of the right side blade.
If the measurement is not at 3", an adjustment must
be made using the cutter deck adjustment lever.
Adjust as follows:
This adjustment will set the cutter deck with no pitch. If
a pitch in the cutter deck is desired, Cutter Deck Pitch
Adjustment on Page 28.
ADJUST HERE
31
A. Loosen the elastic stop nuts securing the deck
level links on the front and rear of the cutter deck. See
Figure 6-7.
B. Turn the adjustment bolts on the front and rear either
clockwise to raise or counterclockwise to lower the
cutter deck until the measurements are equal. Tighten
the elastic stop nuts.
LOOSEN HERE
ADJUST HERE
Figure 6-7. Right Side Cutter Deck Adjustment
R
ADJUST HERE