Kogan 9 Series User Manual page 8

Fix the TV to the wall or pillar
4. To avoid Toppling
In order to reduce harm or injury due to falls in such situations as an earthquake or accidentally knocking the TV, please conduct the following fall prevention
measures.
Depending on the strength of the cabinet or wall where the anchoring solution is attached, the level of protection may be greatly reduced. If this is the case,
please arrange adequate reinforcement.
To avoid the TV from toppling, please fix the TV to a wall or pillar. Install the TV close to a wall to avoid falling backwards.
* Pass the two VESA screws through the two clips and then attach them to the VESA holes on the upper middle of the rear cover.
* Pass the wall screw through the third clip and then attach them to the wall. Make sure the wall screw is attached to a stud, and properly
anchored. Do not simply screw into plaster.
* Pass a string (commercially available) through the three clips.
* Tie the string tightly.
* Make sure that you use a suitable string, wire or chain that has a breaking weight that exceeds the total weight of the television. If you are
unsure, please contact
Customer Support who can assist.
Kogan