Table of Contents
Advertisement
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
Horizontal Line
Horizontal Line
CAUTION: Wear gloves to avoid cutting
CAUTION: Wear gloves to avoid cutting fingers on
fingers on sharp edges.
sharp edges.
1. Draw a horizontal line on the wall at the bottom
of the "Rear Wall Template".
2. Drill ⅝" holes for toggle bolts in 3 locations
(Hole A, Hole B, Hole C) as shown in the
illustration above. If the location of a hole lines
up with a stud, drill a
You cannot use a toggle bolt to attach the wall
plate to a stud.
NOTE: D
O NOT MOUNT THE PLATE AT THIS TIME.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 10
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 10
Centerline
Hole A
Hole A
Centerline
notches
notches
Area E
Area E
/
" hole for a wood screw.
3
16
10
Draw a vertical line on
the wall to mark the
Draw a Vertical Line
center of the cabinet
on Wall from Center
of Top Cabinet
above.
C L
Hole B
Hole B
Draw a horizontal line on the wall along the
Draw a Horizontal line on wall from
bottom of the "Rear Wall Template".
bottom of "Rear Wall Template".
3. Holes A, B and C are inside area E. If none of
these holes line up with a stud, find a stud in
area E that lines up with a hole circle in Area
E, and then drill a
/
" hole into it for a wood
3
16
screw. You must have at least one wood screw
mounted firmly into a stud to support the
weight of the microwave. Set the mounting
plate aside.
Horizontal Line
Horizontal Line
2024-02-16 오전 9:30:35
2024-02-16 오전 9:30:35
Advertisement
Table of Contents
