Step-by-step installation guide
D. ALIGNING THE WALL PLATE
Horizontal Line
CAUTION: Wear gloves to avoid cutting fingers
on sharp edges.
1.
Draw a Vertical line on the wall at the center
of the 30˝ wide space.
2.
Draw a Horizontal line on the wall at the
bottom of "Rear Wall Template".
3.
Drill ⅝˝ holes for toggle bolts on 3 locations
(Hole A, Hole B, Hole C) but if the location of
hole is same as that of stud, drill a
for wood screw. In other words, toggle bolt
can not be used to the location of stud.
NOTE: DO NOT MOUNT THE PLATE AT
THIS TIME.
SMH8165_XAA_DE68-03587A-10_EN.indd 10
Draw a Vertical Line
Centerline
Hole A
on Wall from Center
notches
of Top Cabinet
C L
Area E
Hole C
Draw a Horizontal line on wall from
bottom of "Rear Wall Template˝.
NOTE: Holes A, B and C are inside area E.
If none of A, B and C is in a stud, find a stud
somewhere in area E and draw a forth circle to
line up with the stud. It is important to use at
least one wood screw mounted firmly in a
stud to support the weight of the microwave. Set
the mounting plate aside.
/
˝ hole
3
16
10
Hole B
Horizontal Line
6/19/2019 3:44:33 PM