Aligning The Wall Plate - Samsung ME21M706BAS/AC Installation Instructions Manual

Step-by-step installation guide
D. ALIGNING THE WALL PLATE
Horizontal Line
Horizontal Line
CAUTION: Wear gloves to avoid cutting
CAUTION: Wear gloves to avoid cutting fingers on
fingers on sharp edges.
sharp edges.
1. Draw a Horizontal line on the wall at the bottom
of the "Rear Wall Template".
2. Drill ⅝˝ holes for toggle bolts in 3 locations
(Hole A, Hole B, Hole C) as shown in the
illustration above. If the location of a hole lines up
with a stud, drill a
You cannot use a toggle bolt to attach the wall
plate to a stud.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
SMH1927_XAC_DE68-04108B-06_EN+CFR.indb 10 SMH1927_XAC_DE68-04108B-06_EN+CFR.indb 10
Centerline
Hole A
Hole A
Centerline
notches notches
Area E
Area E
/ ˝ hole for a wood screw.
3
16
Draw a Horizontal line
on the wall along
Draw a Vertical Line
the bottom of on Wall from Center
of Top Cabinet
"Rear Wall Template".
C L
Hole B
Hole B
Draw a Horizontal line on wall from
Draw a Horizontal line on wall from
bottom of "Rear Wall Template".
bottom of "Rear Wall Template".
3. Holes A, B and C are inside area E. If none of
these holes line up with a stud, find a stud in area
E that lines up with a hole circle in Area E, and
then drill a / ˝ hole into it for a wood screw. You
3
16
must have at least one wood screw mounted
firmly into a stud to support the weight of the
microwave. Set the mounting plate aside.
10
Horizontal Line Horizontal Line
2022-01-20 2022-01-20 10:19:09 10:19:09