Advertisement
Quick Links
INSTALLATION AND OPERATING INSTRUCTIONS
I
INSTALLATION AND OPERATING INSTRUCTIONS
I
NSTAL
INSTALLATION AND
QL 420 / 540
CARTRIDGE FILTER
Rainbow Pool Products
®
PO Box 2388, Mansfield Qld 4122
Telephone STD 61-7-3849 5385
1
Facsimile STD 61-7-3849 5384
Email: info@rainbowpoolproducts.com.au
Web: www.rainbowpoolproducts.com.au
Advertisement
Related Manuals for fluidra Viron ASTRAL POOL QL 420
Summary of Contents for fluidra Viron ASTRAL POOL QL 420
- Page 1 INSTALLATION AND OPERATING INSTRUCTIONS INSTALLATION AND OPERATING INSTRUCTIONS NSTAL INSTALLATION AND QL 420 / 540 CARTRIDGE FILTER Rainbow Pool Products ® PO Box 2388, Mansfield Qld 4122 Telephone STD 61-7-3849 5385 Facsimile STD 61-7-3849 5384 Email: info@rainbowpoolproducts.com.au Web: www.rainbowpoolproducts.com.au...
-
Page 2: Important Safety Precautions
IMPORTANT SAFETY PRECAUTIONS ATTENTION INSTALLER: This guide contains important information about the installation, operation and safe use of this product. This information should be given to the owner and/or operator of this equipment after installation or left on or near the filter. ATTENTION USER: This manual contains important information that will help you in operating and maintaining this filter. -
Page 3: General Overview
WARNING : To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. CAUTION : This filter is for use with permanently installed pools and may be used with hot tubs and spas if so marked. -
Page 4: Clamp Installation
Install the pressure gauge (supplied with the filter) into the marked hole in the lid, using Teflon tape on the gauge thread. If the filter is installed below water level, isolation valves must be installed on the inlet & outlet to enable the filter to be dismantled for cleaning without the loss of water from the pool or spa. -
Page 5: Pump Priming
CLEANING Clean the cartridges when the flow to the pool reduces or the pressure gauge increases by 20 kPa or 3 psi. Stop the pump, close valves on the suction and return lines Open the air bleed valve (located in the filter lid). Allow all pressure to be relieved Loosen the brass nut on the clamp using a 3/4”(19mm) wrench, Loosen until you are able to remove the clamp from the filter. -
Page 6: Warranty
Record your Equipment details here for quick reference: Model No.: ____________________________ Serial No.: ____________________________ Initial Pressure (p.s.i): _______________________ WARRANTY AstralPool Australia Pty Ltd (ABN 97 007 284 504) ("AstralPool") provides the following warranty in relation to its CL series cartridge filters ("Product"). The benefits of this warranty are in addition to any rights and remedies imposed by Australian State and Federal legislation that cannot be excluded. - Page 7 The warranty does not extend to: Normal wear and tear; Weather and other environmental conditions including but not limited to storm, flood, and/or heat wave damage; or Service and maintenance items. Examples of exclusions include but are not limited to: ...