4. Operating instructions
4.1 Operating the NL-30 v.3
•
Switch on the press by pressing the power switch located at the rear.
•
Adjust set point temperature (See 4.2.b).
•
Adjust sealing time (See 4.2.a).
•
Adjust the pressure (according to the type of transfer)
•
Place the garment on the lower platen.
•
Place the transfer.
•
Once the heating platen has reached the desired temperature, close the machine with the handle.
•
When the machine is closed, the timer starts running.
•
At the end of the sealing time, the press will open automatically.
•
If you want to interrupt the cycle, you can do it by pushing the stop button located on the control
panel: the press will then open automatically within 2 seconds (see 4.2).
4.1.1 Setting the sealing pressure
The sealing pressure of the NL-30 v.3 can be adjusted by increasing or decreasing the gap between the
two platens. The maximum space between the two platens is 1.5 cm.
•
Unlock the adjusting wheel (1)
•
Turn the adjusting wheel (2) clockwise to increase the pressure, turn counterclockwise to reduce it.
•
The position indicator (3) shows the space between the plates and thus the pressure setting.
•
Lock the adjusting wheel after the desired pressure setting has been selected (1).
1
BACK TO INDEX
For more information about our products and how to contact us, please visit thermopatch.com
2
The value is
the space between
the platens
3
6