Table of Contents
Advertisement
Installation
Depending on the system configuration, all menus are not
displayed.
There is no conventional service menu. All parameters are
defined in the menu-specific settings. Depending on the
configuration of the UI 800 single-family house or multi-family
house, the entire system or only the respective heating circuit
can be controlled.
•
With the < and > keys, change between the menus: <
Overview >< Heating >< 2nd heating circuit >< Hot
Water >< ... >< Holiday >< Away >
•
With the
key, call up the menu-specific settings of the
current menu selected.
Using the / and . Keys, change and select settings.
•
•
With OK values, confirm selection and settings.
•
Exit settings with the d key.
Flashing values can be changed using the / and . keys.
Idle state
After 5 minutes without being operated, the RT 800 switches
the display to idle state. The brightness is reduced and a
screensaver is activated. This screensaver shows the symbol of
the last menu active and its main display.
▶ To deactivate idle state: press any key.
3
Installation
WARNING
Risk of scalding!
If DHW temperatures above 60 °C are set or if thermal
disinfection is activated, a temperature mixing device must be
installed.
4
3.1
Installation location
Do not install the remote control in wet rooms (e.g. bathroom).
To ensure that the remote control can be hooked in and out
easily, and for the optimum measurement of the room
temperature:
▶ Observe the minimum clearances.
▶ Observe the free space above and below the RT 800.
▶ Install it far from heat sources.
▶ Ensure that there is air circulation.
600
≥ 1000
Ok
Ok
Fig. 4
Installation location in the reference room
Ok
0010038006-001
RT 800 – 6721838942 (2023/01)
Advertisement
Table of Contents
