Table of Contents
Advertisement
TTB958GLG by TITAN
Glue operation
1.
gun.
2. Slide a glue stick (12) in the feed channel (5) until it stops.
3. To turn on the hot glue gun, press and hold the on/off switch (4) for 3 second
until the power indicator (3) turns green and the temperature indicator (2)
turns red.
4. Let the hot glue gun preheat before using the trigger (8). When the hot glue
gun has reached its working temperature, the temperature indicator (2) turns
green.
NOTE: The adhesive will soon harden. It is important to quickly
bond materials together. Press them together for approximately 30
seconds. After about 5 minutes, the bonding area becomes elastic.
Please note that this information depends on temperature and
material.
5. Close the stand holder (9).
6. Always hold the main grip (6)
and point the nozzle (1) of
the glue gun on the surface to
be processed and apply the
glue by keeping the trigger (8)
pressed evenly. Repeat this
step as needed. If it becomes
hard to squeeze more glue out,
just wait 15 seconds for the new
section of glue to melt in the
feeding channel (5) (Fig. 8).
7. If you need to put the glue gun
down, always ensure you unfold
the stand holder (9) and place it
on a level heat proof surface.
8. Put a heat proof tray (not supplied) under the nozzle to collect glue drops.
NOTE: When the glue stick is worn out so that it cannot be pushed
further into the nozzle (1) with the trigger (8), insert a new glue stick
with the same type in the feed channel (5) until it stops. Do not try to
remove the used glue stick from the feeding channel (5). Once used,
a glue stick (12) must be used up completely.
MNL_Greatstar_3.6V Glue Gun_V3_230526.indd 21
1
9
Fig. 8
Operation
12
5
6
8
5/26/23 2:44 PM
EN
EN
21
Advertisement
Table of Contents
