Table of Contents
Advertisement
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡ In networked standby mode, the appliance requires
a maximum of 2 W.
¡ Hobs are not designed to be left unattended. Al-
ways monitor the cooking process.
25.1 Setting up the Home Connect app
Install the Home Connect app on your mobile
1.
device.
Start the Home Connect app and set up access for
2.
Home Connect.
The Home Connect app guides you through the en-
tire login process.
25.3 Overview of the Home Connect settings
You can adjust the settings and network settings for Home Connect by going to your hob's basic settings.
Setting
Selection or display
Network connection
– Not connected/disconnect network
– Connect automatically
– Connect manually
– Connected
Connection to app
– Not connected
– Connect
Connection to the Wi-Fi
– Wireless module switched off
– Wireless module switched on
Set using the app
– Switched off
– Switched on
Software update
– Update available and ready to in-
stall
– Start installation
Controlling remote access by after-
sales service
– Not authorised
– Authorised
1
Factory setting
1
25.2 Setting up Home Connect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The Home Connect app has been installed on your
mobile device.
¡ The appliance is receiving signals from the WLAN
home network (Wi-Fi) at its installation location.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
Open the Home Connect app and scan the follow-
1.
ing QR code.
2.
Follow the instructions in the Home Connect app.
Additional information
Log on the hob in the Wi-Fi home network (Wi-Fi) or dis-
connect from the network
is only displayed if the hob is connected to the
home network.
If Wi-Fi has been activated, you can use the Home Con-
nect functions.
is only displayed if the hob has been previously
connected to a network.
If
is switched off, only the hob's operating statuses
are displayed in the Home Connect app.
is only displayed if a software update is available.
is only displayed if after-sales service is attempting
to connect to the hob. After granting access, you can ter-
minate this at any time.
Home Connect en
25
Advertisement
Table of Contents
