Table of Contents
Advertisement
26
Troubleshooting
Should you have any problems during the operation of this stereo system please check that all the controls are set to their proper po-
sitions and that all the connections are correct (refer to this manual for the proper procedures). Ifa problem persists refer to the advice
below.
.
:
If the problem can not be corrected with the instructions below, write down the model and serial numbers and all pertinent data re-
garding warranty coverage, as well as a clear description of the problem and contact your nearest AKAI service centre.
PROBLEM
CHECK POINT
@ No power.
@ Make sure power cord is connected securely to household AC out-
@ No sound.
let.
@ Make sure all connections are secure.
@ Make sure head phones are not connected to PHONES jack.
@ Make sure muting is not engaged.
@ Check station tuning.
@ Make sure input selector and volume control are set properly.
@ Make sure CD or cassette tape is loaded properly.
e@ Bass or stereo sound is not reproduced fully.
®@ Speaker system connections are not correct.
Make sure polarity of speaker connections are correct.
@ Random playback does not function.
@ Programme playback has not been cancelled.
Press the CLEAR button to cancel programme playback.
@ Distorted playback or sound loss during CD play-
® CD is dirty or scratched.
back.
@ Distorted recording or playback.
@ Dirty recording or playback head.
@ Edit recording does not operate.
@ CD and cassette tapes are not loaded.
@ input selector is not set to CD.
@ Edit programming has not been completed.
® Humming noise during record playback.
@ Ground wire of turntable is not connected to amplifier's GND termi-
nal.
@ IPSS or intro scan does not function.
@ Blank spaces between selections are less than 4 seconds long.
® Recording does not function.
@ Recording defeat tabs on cassette tape have been removed.
@ Input selector is not set to proper position.
@ Play button has not been pressed after pressing REC PAUSE button.
@ REC PAUSE button has not been pressed.
@ Weak batteries.
Replace the batteries.
@ Obstacle in front of remote sensor window.
@ TAPE OPERATION button has not been pressed to set the buttons
for desired deck operation.
@ Remote control does not operate.
@ Tape operation buttons can not be operated.
@ Clock is not set to present time.
@ "TIMER REC' or "TIMER WAKE" indicator is not lit.
@ CDor cassette tape has not been loaded.
@ Stations have not been memorized.
@ Dirty heads, capstans, tape guides or pinch rollers
@ Timer recording or wake up function does not
operate.
@ Wow and flutter in sound.
Advertisement
Table of Contents
