Zanussi DF 102T Instruction Booklet page 8

CLEANING THE
INSIDE
Wash the inside of the ap¬
pliance with lukewarm water
and a little bicarbonate of so¬
da (1 teaspoonful to 1.2 litre/2
pints of water). Do not use
soap or detergent as the smell
might linger. Dry thoroughly.
Do not allow water to run
into the two small grills on the
base at the front of the super¬
chill compartment, as these
grills are airways between the
superchill and freezer com¬
partment and the water could
freeze and block the airways.
CHANGING
THE OPENING
DIRECTIONS OF
THE DOORS
The appliance is normally
supplied with doors which
open from left to right. To
change the opening direc¬
tions, follow the instructions
below:
Bottom door:
1. Unclip and remove the
ventilation grill (A).
2. Unscrew and remove the
lower hinge (B) and slide
the lower door from its top
hinge.
3. Unscrew the pin (C) from
the hinge and refit it onto
the hinge on the opposite
side.
3a. There is a plastic skin over
the new hinge hole. This
should be opened up with
the use of a tool such as a
screwdriver. Plug old hole
with blank supplied.
4. Refit the lower door onto
the pin (C) and reassemble
the lower hinge (B) on the
opposite side.
5. Break off the insert (D)
from the ventilation grill.
You may need a pair of pli¬
ers for this.
6. Fit the insert (E) (suppli¬
ed with the appliance)
into the plinth ventila¬
tion grill on the other
side.
7. Refit the ventilation grill
(A) clipping it into posi¬
tion.
Top Door
8. Remove the hinge cover
(F), unscrew the hinge (G)
and slide the upper door
out with its washer (H).
9. Unscrew the pin (I) from
the hinge (G) and refit
the pin onto the same
hole, but on the opposite
side of the hinge.
10. Unscrew the pin (L) from
the upper hinge and refit
it on the hinge on the op¬
posite side.
10a. There is a plastic skin
over the new hinge hole.
This should be opened up
with the use of a tool
such as a screwdriver.
Plug old hole with blank
supplied.
11. Slide the upper door into
the pin (L), ensuring that
the washer (H) is in posi¬
tion between the door
and pin, reassemble the
hinge (G) and the hinge
cover (F) on the opposite
side.
8