Zanussi DF 102T Instruction Booklet page 7

WARNING
THIS APPLIANCE MUST
BE EARTHED.
The manufacturer declines
any liability should this safe¬
ty measure not be observed.
If the plug that is fitted to
your appliance is not suitable
for your socket outlet, it must
be cut off and the appropriate
plug fitted.
The cut off plug should be dis¬
posed of to prevent the hazard
of electric shocks in case it
should be plugged into a 13
Amp socket in another part of
your home.
IMPORTANT
The wires in the mains lead
are coloured in accordance
with the following code:
GREEN AND YELLOW-
EARTH
BLUE-NEUTRAL
BROWN-LIVE
If you fit your own plug the
colours of the wires in the
mains lead of your appliance
may not correspond with the
markings identifying the
terminals in your plug.
This is what you have to do:
Connect the green and yel¬
low (earth) wire to the termi¬
nal in the plug which is
marked with the letter «E» or
the earth symbol or col¬
oured green or coloured green
and yellow.
Connect the blue (neutral)
wire to the terminal in the
plug which is marked with
the letter «N» or coloured
black.
Connect the brown (live)
wire to terminal in the plug
with the letter «L» or col¬
oured red.
The plug moulded onto the
cord incorporates a fuse, for
replacement, use a 13 Amp
BS1362 fuse. Only ASTA ap¬
proved fuses should be used.
The fuse cover/carrier col¬
our is the one shown by the co¬
loured insert at the base of the
plug.
The plug must not be used
if the fuse cover/carrier is
lost. A replacement cover/
carrier must be obtained from
Zanussi Service Agents whose
addresses are listed on the
attached Zanussi Service
Force Nationwide.
This appliance complies
with E.E.C. directive number
82/499 of 7.6.82 relative to ra¬
dio interference suppression.
To start the cooling system,
insert the plug into the wall
socket and switch on.
■ 7