Table of Contents
Advertisement
Current time setting
■ When inserting the batteries, the current time is automatically set to time setting mode.
13:00 is displayed as the current time. Set the clock to the right time.
AUTO mode operation
■ Automatically selects the operation mode (COOL, HEAT) depending on the room temperature when switched on.
RLH012A503_EN.indd 14
RLH012A503_EN.indd 14
Example: Set to 10:30.
1
Press the TIME SET UP switch.
Press with the tip of a ballpoint pen, etc.
The time display flashes and can be set to the current time.
2
Press the " or
(TEMP/TIMER)" button.
(Set to 10:30)
3
Press the ON/OFF button.
The time display changes from flashing to steady lighting and the setting is
complete.
Make sure to press the button within 60 seconds from the last operation in
step 2, otherwise the time will not be set.
NOTICE
• The timer operation works based on the time clock, so set it correctly.
• The remote control data will be reset when the present time is set.
• When the battery of the remote control is replaced or the ACL switch is
pressed, the remote control will be set to the initial state.
1
Press the MODE button.
The mode changes whenever the button is pressed.
Set to
.
2
Press the ON/OFF button.
To stop:
• If you do not want the AUTO mode program, change to COOL, HEAT or FAN
instead of AUTO.
• Airflow direction adjustment procedure.
NOTICE
• In case air is not blowing out during the operation.
EN-14
Press the ON/OFF button.
Page 16
Page 17
Page 31
2023/04/28 10:32
2023/04/28 10:32
Advertisement
Table of Contents
