Rockwell RCV288ACx Command Reference Manual page 176

T
V0
V1
W0
W1
W2
X0
X1
X2
X3
X4
Y0
Y1
Z0
Z1
&C0
&C1
&D0
&D1
&D2
&D3
&F0
&F1
&G0
&G1
&G2
&J0
&J1
&K0
&K3
&K4
&K5
&K6
&L0
* Serial interface operation only.
8-2
AT Command Reference Manual
Force DTMF dialing.
Report short form (terse) result codes.
Report long form (verbose) result codes.
Report DTE speed in EC mode.
Report line speed, EC protocol and DTE speed.
Report DCE speed in EC mode.
Report basic call progress result codes, i.e., OK, CONNECT, RING, NO CARRIER (also,
for busy, if enabled, and dial tone not detected), NO ANSWER and ERROR.
Report basic call progress result codes and connections speeds (OK, CONNECT, RING,
NO CARRIER (also, for busy, if enabled, and dial tone not detected), NO ANSWER,
CONNECT XXXX, and ERROR.
Report basic call progress result codes and connections speeds, i.e., OK, CONNECT,
RING, NO CARRIER (also, for busy, if enabled, and dial tone not detected), NO
ANSWER, CONNECT XXXX, and ERROR.
Report basic call progress result codes and connection rate, i.e., OK, CONNECT, RING,
NO CARRIER, NO ANSWER, CONNECT XXXX, BUSY, and ERROR.
Report all call progress result codes and connection rate, i.e., OK, CONNECT, RING, NO
CARRIER, NO ANSWER, CONNECT XXXX, BUSY, NO DIAL TONE and ERROR.
Disable long space disconnect before on-hook.
Enable long space disconnect before on-hook.
Restore stored profile 0 after warm reset.
Restore stored profile 1 after warm reset.
Force RLSD active regardless of the carrier state.
Allow RLSD to follow the carrier state.
Interpret DTR ON-to-OFF transition per &Qn:
&Q0, &Q5, &Q6
&Q1, &Q4
&Q2, &Q3
Interpret DTR ON-to-OFF transition per &Qn:
&Q0, &Q1, &Q4, &Q5, &Q6
&Q2, &Q3
Interpret DTR ON-to-OFF transition per &Qn:
&Q0 through &Q6
Interpret DTR ON-to-OFF transition per &Qn:.
&Q0, &Q1, &Q4, &Q5, &Q6
&Q2, &Q3
Restore factory configuration 0.
Restore factory configuration 1.
Disable guard tone.
Disable guard tone.
Enable 1800 Hz guard tone.
Set S-Register response only for compatibility.
Set S-Register response only for compatibility.
Disable DTE/DCE flow control.
Enable RTS/CTS DTE/DCE flow control.
Enable XON/XOFF DTE/DCE flow control.
Enable transparent XON/XOFF flow control.
Enable both RTS/CTS and XON/XOFF flow control.
Select dial up line operation.
The modem ignores DTR.
The modem hangs up.
The modem hangs up.
Asynchronous escape.
The modem hangs up.
The modem hangs up.
The modem performs soft reset.
The modem hangs up.
1048