Philips WelcomeEye Touch Instructions For Using Manual page 12

6 – Connect the two intercom panel wires and the two power supply wires following the
wiring diagram.
7 - Position the monitor on the wall bracket.
8 - Depending on the configuration selected, and when wiring is completed, the interface
may have to be configured.
Warning: during this step, do not connect the power supply to the 230V AC.
4. Installation of the main or additional intercom panel
Warning: The product must not be connected to the power supply before the wiring has
been completed.
1
4
DES 9900 VDP
5 3 1 0 0 6
1 2
1 2
1 2 3 4 5 6 7 8
1 2
DES 9901 VDP
Avidsen
5 3 1 0 0 6
19 avenue Marcel Dassault
37200 TOURS
FRANCE
20V 110mA
RFID 125kHz
IP44
7
1 - Remove the tamper-resistant screw from underneath the intercom panel, using the key
provided.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
F8
2
5
2 1
2
8
WelcomeEye Connect 2 / Touch / V4
3
6
1
9
*
1m60