Hammond Manufacturing ECP Series Assembly Instructions

ECP - SERIES
ASSEMBLY INSTRUCTIONS FOR COUPLINGS AND SUPPORT
BRACKETS ON ECLIPSE COMMAND ENCLOSURES
ASSEMBLY INSTRUCTIONS
FASTEN SUPPORT BRACKET (PART 2) TO
A)
THE INSIDE OF THE ECP ENCLOSURE
USING 1/4 - 20 KEP NUTS (PART 5) OVER
THE FOUR STUDS IN THE ENCLOSURE.
ASSEMBLE THE COUPLING (PART 1) TO B)
THE ENCLOSURE WITH THE GASKET
(PART 3) TO OUTSIDE AND METAL RING
(PART 4) TO INSIDE AS SHOWN TO THE
RIGHT.
FASTEN THE COUPLING TO ENCLOSURE C)
USING 4 SOCKET SCREWS (PART 6).
PART # QTY. DESCRIPTION
1 1 COUPLING
2 1 SUPPORT BRACKET
3 1 GASKET
4 1 METAL RING (ON 50
& 80 SERIES ONLY)
5 4 1/4 - 20 KEP NUT
6 4 M6 OR M8 SOCKET
TOOL BOX
3/8 or 7/16" Socket
Wrench or Driver
1/4 - 20 STUDS INSIDE
SCREW
5mm or 6mm
Allen Key
A (DEPTH OF
ENCLOSURE)
B
ECP ENCLOSURE
ECP
ENCLOSURE
4
6
Tape
"C" Clamp
Measure
PAGE 1 OF 3
BUL10256
PRE ASSEMBLY INSTRUCTIONS
A)
CENTER THE SUPPORT BRACKET (PART 2)
ON WIDTH AND DEPTH OF THE
ENCLOSURE. SEE CHART BELOW. CLAMP
DOWN THE BRACKET AT THE LOCATION
GIVEN BELOW ON THE OUTSIDE OF THE
ENCLOSURE.
B)
CHECK THE 3 DRILL PATTERNS ON PAGE 2
FOR THE PATTERN THAT APPLIES TO THE
COUPLING (PART 1) PURCHASED. USING
THE SUPPORT BRACKET AS A TEMPLATE,
MARK AND DRILL THROUGH THE ECP
ENCLOSURE AS SHOWN.
C)
ASSEMBLE THE COUPLING TO THE
ENCLOSURE AS PRE-ASSEMBLY
INSRUCTIONS.
ECP # A
ECP12126 6" (152.5mm)
ECP12168 8" (203mm)
ECP161610 10" (254mm)
ECP162010 10" (254mm)
ECP202412 12" (305mm)
ECP20246 6" (152.5mm)
1
3
HAMMOND
MANUFACTURING
ENCLOSURES
REV. D
B
.125" (3.2mm)
1.125" (28.6mm)
2.125" (54mm)
2.125" (54mm)
3.125" (79.4mm)
.125" (3.2mm)
2
5
TM