Turning On And Off The Tv; Programme Selection; Volume Adjustment; Changing The Input Source - Changhong Electric 4500 Series Operation Manual

Basic Operation

Turning on and off the TV

■ Turn on the TV
Connect the TV to your mains socket. If TV has a power switch,turn it on firstly.
Then press the
■ Turn off the TV
Press the
Do not leave your set in standby mode for long periods of time. It is best to unplug
the set from the mains and aerial.
When there is an accident power off, it is recommended to unplug the power cable
from the power socket.
■ No signal
There is No Signal menu on screen when there is no input signal. In ATV mode, if
there is no signal in five minutes, the TV will turn off automatically. In PC-RGB mode,
the TV set will automatically turn off in 30 seconds if no input signal. When VGA cable
is connected, the TV turns on automatically.

Programme Selection

■ Using the CH+/CH- on the panel of TV or on the remote control.
Press CH+ to increase channel number.
Press CH - to decrease channel number.
■ Using 0- 9 Digital Buttons.
You can select the channel number by pressing 0 to 9. (In TV, DTV mode)
■ Example
To select - channel (e.g. Channel 5): Press 5.
To select -- channel (e.g. Channel 20): Press 2 and 0 in a short time.

Volume Adjustment

■ Press the VOL+/- button to adjust the volume.
■ If you want to switch the sound OFF, press the
■ You can release mute by pressing the

Changing the Input Source

1. You can select the input source by pressing the SOURCE
button on the remote control.
2. Press the▲/▼button to cycle through the input source, a
press the ENTER button to confirm your choice.
NOTE:
• The picture is just for reference. Please operate with the O
MENU of concrete TV and refer to the AV terminal board
button on the remote to turn on the TV.
button on the remote control to enter standby mode.
.
or increase the volume.
English14
nd
SD
.