Basic Operation; Installation Guide; Turning On And Off The Tv; Programme Selection - Changhong Electric LED50C2000A Operation Manual

Basic Operation

Installation Guide

When the TV is initially powered on, a sequence of on-screen prompts will assist in
configuring basic settings.
1. Selecting a language
Select the desired OSD language, then press the ► button to go to the next page.
2. Selecting a picture mode
Select the desired picture mode, then press the ► button to go to the next page.
3. Selecting a country
Select the appropriate country, then press the ► button to start auto tuning.
4. Auto Tuning
Scans for channels automatically and stores them in the TV's memory.

Turning on and off the TV

■ Turn on the TV
Connect the power cable, and press the
■ Turn off the TV
Press the
Do not leave your set in standby mode for long periods of time. It is best to unplug the
set from the mains and aerial.
When there is an accident power off, it is recommended to unplug the power cable
from the power socket.
■ No signal
There is No Signal menu on screen when there is no input signal. In TV mode, if there
is no signal in 5 minutes, the TV will turn off automatically. In PC-RGB mode, the TV set
will automatically turn off in 1 minute if no input signal. When VGA cable is connected,
the TV turns on automatically.

Programme Selection

■ Using the CH+/CH- on the panel of TV or on the remote control.
Press CH+ to increase channel number.
Press CH - to decrease channel number.
■ Using 0- 9 digital buttons.
You can select the channel number by pressing 0 to 9. (In ATV, DTV mode)
■ Example
To select - channel (e.g. Channel 5): Press 5.
To select -- channel (e.g. Channel 20): Press 2 and 0 in a short time.

Volume Adjustment

■ Press the VOL+/- button to adjust the volume.
■ If you want to switch the sound OFF, press the
■ You can release mute by pressing the
button on the remote control to enter standby mode.
button to turn on the TV.
.
or increase the volume.
11