Table of Contents
Advertisement
Character Codes/Line Feed Method
• When this interface is used with the Typestar 7, you can choose
between the ASCII and LOCAL character code settings. (The ini-
tial setting is for the ASCII character code.) The setting for the
S-15 and S-16 is factory preset and cannot be changed. Note also
that the character codes for the S-15 and S-i6 are different from
those for the Typestar 7. (See pages 15-18 for character code
tables.)
• When the CR code (0DH) is received, you can choose between
two types of line feed: a carrier return only (CR), or a carrier
return plus line feed (CR/LF). (The initial setting is CR/LF.)
These settings will remain effective until changed. (The settings are retained in the
memory when the power is turned off
if
dry batteries or the NiCd battery pack
is •
installed, or the AC adapter is connected.
When using the S-15 or S-16
On the S-15, current settings are printed out, and on the S-16 they
are shown on the display. When using the S-15, be sure to insert a
sheet of paper before making settings.
1. Press the
IJ2QPE:J
key and then the
[M]
key.
The message "BAUD RATE : 1200" will be printed out by the
S-15 and shown on the S-16 display.
2. Press the
I
RE:TLJRN]
key four times.
The following will be printed out or displayed in order: BIT
LENGTH : 7, PARITY BIT: EVEN, STOP BIT: 1. Then, CR
CR/LF : CR/LF will be printed out or shown on the display. (It
is not necessary to set BAUD RATE, BIT LENGTH, PARITY
BIT, or STOP BIT.)
3. Each time the
I
BACKSPACE
I
key (or
EJ
and
G
keys ori the
S-16) is pressed, the line feed method setting will alternate be-
tween CR and CR/LF in the printout or on the display.
10
Advertisement
Table of Contents
