Cassette Deck Alignments; Record/Reproduce - Revox C115 Operating And Service Instructions

E 16 C115
4.2 Cassette deck alignments
The tape deck is factory aligned. If the complete cassette
deck is replaced, only an electronic azimuth check needs
to be performed.
If realignment is necessary for any reason, the cassette
tape deck must be removed. A soundhead alignment
gauge (1) Part No. 46172 is required.
To remove the cassette tape deck proceed according to
2.2/2.3.
4.2.1 Record / reproduce head
1. Check the height and parallel alignment of the
soundheads with the aid of the vernier calipers (2).
2. Adjust the height and the parallel alignment with the
three adjustment screws (3).
3. Correct the azimuth with the adjustment screw (4).
4. Before reinstallation, carefully clean all cassette deck
components and demagnetize the soundheads.
(--> 4.1.2).
5. For fine-adjustment install the cassette deck, remove
the cassette deck trim strip, and play the reference
cassette (Part No. 46034).
6. Align for minimum phase error with the azimuth ad-
justment screw (4), using the 10 kHz signal.
REVOX®