Table of Contents
Advertisement
SECTION 5
DISASSEMBLY
IMPORTANT NOTE :
The IMEI Sticker mounted on the main board (visible from the battery compartment) should not be removed at all.
The IMEI number is the electronic identification of the hardware, and it is stored electronically.
There should be no discrepancy between the number on the sticker and the number within the set logic allowed.
Remove
the
battery
and
the
4
Insert the hook release jig (p/n 3-043-180-01)
in the gap
screws
in the battery compartment.
between upper and lower case. Then gently slide the jig in
Note
that
the
SIM
card
is also
the direction of the white arrow. This is to release the claws
located in this area
between
the upper and
lower case
(as indicated
by the
black arrows).
Important: Do not insert the hook release jig too deep
into the gap, that might result in damaging
the PWB
while sliding the jig.
The front cosmetic and back cosmetic can now be
separated, and the main board can be taken out.
14
Advertisement
Table of Contents
