Advertisement
LOWER
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
FIGURE 2.6
FIGURE 2.4
2.2.3. PROPELLING MOWER
(Self Propelled Models)
1. Move ground speed control to the desired speed
position. See Figure 2.5.
2. Move wheel drive control against handle to
engage wheel drive and propel mower forward.
Forward speed can be adjusted while the mower is
moving by changing position of the ground speed
control. See Figure 2.5.
1. Move e-ore sc-eec control to the "Fast" (Rabbit)
position.
3qe
Figure 2.4.
2. p.sh shinier button three times to start a cold
engine
\:~E. I : -ot use primer button to start
warm
etug
*©
(SLOW)
ONE SPEED
2.4
-A',DLE HEIGHT ADJUSTMENT
he hergrrt of the mower handle can be adjusted as
follows
1
_ooser the lower nuts on each lower handle as
show" " -igure 2.6.
HIGHER
LOWER
HANDLE
BLADE
CONTROL
CATCHER MODEL SHOWN
(ROPE START MOUNTED ON
LEFT SIDE OF HANDLE)
Section 2 - OPERATING INSTRUCTIONS
CATCHER MODEL SHOWN
(ROPE START MOUNTED ON
LEFT SIDE OF HANDLE)
(FAST)
SIX SPEED
POSITION
NOTE:
Stop
tjne engine
(and blade) by releasing the
blade CDntrri'
2. Pu Made control against handle.
3. Pu
mope
~z~
candle until engine starts. See
Figure 2 j.
4. Afle- angare starts, allow a brief warm-up until
engine rjrs smooth.
PULL ROPE START
TURN KEY SWITCH
HANDLE TO S" Ar
_TO RUN POSITION
ENGINE-v
BLADE
CONTROL
WHEEL DRIVE
CONTROL
FIGURE 2.5
MOVE CONTROL
AGAINST HANDLE
TO ENGAGE
WHEEL DRIVE
2.3
STOPPING
1. Stop engine and blade by releasing the blade
centre
Stop forward motion of mower by releasing
me -vee drive control.
2.2
STARTING & OPERATION (Continued)
2.2.2. ENGINE & BLADE
(Primer Voces
Recoil Start)
If the baten
:s :eac
:-too weak to crank engine use
the recoi
zsaouc
MOVE GROUND SPEED
CONTROL TO DESIRED
POSITION
A
WARNING
A
Stop engine and mower blade before adjusting
handle height
2. Move upper mower handle up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to
maintain desired position.
6
Advertisement
